The CARBS is the culmination of years of dealing with frustrating outer belts in 3Gun competition. Whether it is needed help to get the belt on, belts falling off, bouncing around or just simply not tight enough, we have sought to improve the belt system.
The CARBS outer belt hole patterns accept ELS and TMMS female brackets allowing easy swapping of your male bracket attached gear. You can also direct mount holsters, pouches and shot shell holders to the belt panel. Brackets and pouches are NOT included. One side is lined with velcro to mate to your inner belt (or add one from the drop down). To add brackets, just use a sharp instrument to puncture the velcro and press the fastener through, then tighten per the manufacturers recomendations.
NOTE: Be sure to NOT let the barbs from T-nuts poke (grind off the tips) into the polymer panel or it may fail. We will not waranty abuse in that case. Especially for holster hangers, we suggest only mounting the hanger with two attachments vertically. So one of the vertical slots and the corresponding horizontal slot above it. That reduces the severe bending.
Measurements are actual for the outer belt. To get the best fit, measure the circumference of your waist with your normal shooting clothes and inner belt on (or a lether belt) and order a belt that has that number in the range. If you order the wrong size, we will exchnage it for you provided you pay for the shipping both ways, but better to measure correctly. The 7" strap results in about 6 inches of useable adjustment.